ip rip invalid-timer
Configures the RIP invalid timer value that defines the time interval during which a route will remain
active in Routing Information Base (RIB) before moving to the invalid state.
ip rip invalid-timer seconds
Syntax Definition
seconds
Defaults
parameter
seconds
Platforms Supported
OmniSwitch 6250
Usage Guidelines
The invalid time interval value must be three times the update interval value.
Examples
-> ip rip invalid-timer 270
Release History
Release 6.6.1; command was introduced.
Related Commands
show ip rip
MIB Objects
alaProtocolRip
alaRipInvalidTimer
page 33-20
The RIP invalid timer value, in seconds. The valid range is 3–360.
default
180
Displays the RIP status and general configuration parameters (e.g.,
forced hold-down timer).
OmniSwitch 6250 CLI Reference Guide
RIP Commands
November 2009