RIP Commands
ip rip host-route
Specifies whether or not RIP can add host routes (routes with a 32-bit mask) to the RIP table.
ip rip host-route
no ip rip host-route
Syntax Definitions
N/A
Defaults
The default is to enable a default host route.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to prevent RIP from adding host routes to the RIP table.
•
When enabled, RIPv1 will interpret an incoming route announcement that contains any 1 bit in the host
portion of the IP address as a host route, implying a mask of 255.255.255.255.
Examples
-> ip rip host-route
Release History
Release 6.6.1; command was introduced.
Related Commands
show ip rip routes
MIB Objects
alaProtocolRip
alaRipHostRouteSupport
OmniSwitch 6250 CLI Reference Guide
Displays the RIP Routing Database.
November 2009
page 33-15