Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 1364

output definitions
Holddown interval
Forced Hold-Down Timer
Release History
Release 6.6.1; command was introduced.
Related Commands
ip rip status
ip rip force-holddowntimer
ip rip update-interval
ip rip invalid-timer
ip rip garbage-timer
ip rip holddown-timer
MIB Objects
alaProtocolRip
alaRipProtoStatus
alaRipRouteNumber
alaRipHostRouteSupport
alaRipRedistRouteTag
alaRipUpdateInterval
alaRipInvalidTimer
alaRipGarbageTimer
alaRipHolddownTimer
alaRipForceHolddownTimer
page 33-24
The hold-down time interval, in seconds. Valid range is 0–120. Default
is 0.
The forced hold-down time interval, in seconds. The valid range is
0–120. Default is 0.
Enables/disables RIP routing on the switch.
Configures the interval during which a RIP route remains in the
forced hold-down state.
Configures the time interval during which RIP routing updates are
sent out.
Configures the RIP invalid timer value that defines the time interval
during which a route will remain active in Routing Information
Base (RIB) before moving to the invalid state.
Configures the RIP garbage timer value that defines the time inter-
val, which must elapse before an expired route is removed from the
RIB.
Configures the RIP hold-down timer value that defines the time
interval during which a route remains in the hold down state.
OmniSwitch 6250 CLI Reference Guide
RIP Commands
November 2009