Show Ip Rip - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

RIP Commands

show ip rip

Displays the RIP status and general configuration parameters (e.g., forced hold-down timer).
show ip rip
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
N/A
Examples
-> show ip rip
Status
Number of routes
Host Route Support
Route Tag
Update interval
Invalid interval
Garbage interval
Holddown interval
Forced Hold-Down Timer
output definitions
Status
Number of routes
Host Route Support
Route Tag
Update interval
Invalid interval
Garbage interval
OmniSwitch 6250 CLI Reference Guide
= Enabled
= 9
= Enabled
= 42
= 30
= 180
= 120
= 0
= 0
RIP status (Enabled or Disabled).
Number of network routes in the RIP routing table.
Host route status (Enabled or Disabled). Indicates whether or not RIP
can add host routes (routes with a 32-bit mask) to the RIP table.
Route tag value for RIP routes generated by the switch. Valid values are
0–2147483647.
The RIP routing update interval, in seconds. Valid range is 1–120.
Default is 30.
The RIP invalid timer value, in seconds. Valid range is 3–360. Default
is 180.
The RIP garbage timer value, in seconds. Valid range is 0–180. Default
is 120.
November 2009 page 33-23