Ip Rip Holddown-Timer - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

ip rip holddown-timer

Configures the RIP hold-down timer value that defines the time interval during which a route remains in
the hold-down state.
ip rip holddown-timer seconds
Syntax Definition
seconds
Defaults
parameter
seconds
Platforms Supported
OmniSwitch 6250
Usage Guidelines
When RIP detects a route with higher metric than the route in the RIB, the route with the higher metric
goes into the hold-down state. The route updates with a metric of INFINITY are rejected.
Examples
-> ip rip holddown-timer 10
Release History
Release 6.6.1; command was introduced.
Related Commands
show ip rip
MIB Objects
alaProtocolRip
alaRipHolddownTimer
page 33-22
The hold-down time interval, in seconds. The valid range is 0–120.
default
0
Displays the RIP status and general configuration parameters (e.g.,
forced hold-down timer).
OmniSwitch 6250 CLI Reference Guide
RIP Commands
November 2009