ip rip interface status
Enables/disables a RIP interface. By default, a RIP interface is created in the disabled state. After creating
a RIP interface, you must use this command to enable the interface.
ip rip interface {interface_name} status {enable | disable}
Syntax Definitions
interface_name
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
You must first create a RIP interface by using the
face.
•
You can create a RIP interface even if an IP router interface has not been configured. However, RIP
will not function unless an IP router interface is configured with the RIP interface.
•
For more information on VLANs and router ports, see
Examples
-> ip rip interface rip-1 status enable
Release History
Release 6.6.1; command was introduced.
page 33-6
The name of the interface.
default
disable
ip rip interface
Chapter 22, "VLAN Management
OmniSwitch 6250 CLI Reference Guide
RIP Commands
command before enabling the inter-
Commands".
November 2009