DHCP Relay Commands
ip helper boot-up
Enables or disables automatic IP address configuration for default VLAN 1 when an unconfigured switch
boots up. If enabled, the switch broadcasts a BootP or a DHCP request packet at boot time. When the
switch receives an IP address from a BootP/DHCP server, the address is assigned to default VLAN 1.
Note. Automatic IP address configuration only supports the assignment of a permanent IP address to the
switch. Make sure that the DHCP server is configured with such an address before using this feature.
ip helper boot-up {enable | disable}
Syntax Definitions
enable
disable
Defaults
By default, this feature is disabled on the switch.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the
ip helper boot-up enable
•
If an IP router port already exists for VLAN 1, a request packet is not broadcast even if automatic IP
address configuration is enabled for the switch.
Examples
-> ip helper boot-up enable
-> ip helper boot-up disable
Release History
Release 6.6.1; command was introduced.
Related Commands
ip helper boot-up enable
MIB Objects
iphelperStatTable
iphelperBootupOption
OmniSwitch 6250 CLI Reference Guide
Enables automatic IP address configuration for default VLAN 1.
Disables automatic IP address configuration for default VLAN 1.
command to specify BootP or DHCP for the request packet type.
Specifies BootP or DHCP as the type of request packet the switch will
broadcast at boot time.
November 2009
page 32-41