Chapter 33 Rip Commands - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Routing Information Protocol (RIP) is an Interior Gateway Protocol (IGP) that uses hop count as its rout-
ing metric. RIP-enabled switches update neighboring switches by transmitting a copy of their own routing
table. The RIP routing table always uses the most efficient route to a destination, that is, the route with the
fewest hops and longest matching prefix.
The switch supports RIP version 1 (RIPv1), RIP version 2 (RIPv2), and RIPv2 that is compatible with
RIPv1. It also supports simple and MD5 authentication, on an interface basis, for RIPv2.
The RIP commands comply with the following RFCs: RFC1058, RFC2453, RFC1722, RFC1723, and
RFC1724.
MIB information for the RIP commands is as follows:
Filename: RIPv2.mib
Module: rip2
Filename: AlcatelIND1Rip.mib
Module: alaRipMIB
A summary of the available commands is listed here:
ip load rip
ip rip status
ip rip interface
ip rip interface status
ip rip interface metric
ip rip interface send-version
ip rip interface recv-version
ip rip force-holddowntimer
ip rip host-route
ip rip route-tag
ip rip interface auth-type
ip rip interface auth-key
ip rip update-interval
ip rip invalid-timer
ip rip garbage-timer
ip rip holddown-timer
show ip rip
show ip rip routes
show ip rip interface
show ip rip peer
OmniSwitch 6250 CLI Reference Guide
33 RIP Commands
November 2009 page 33-1