Ip Rip Status - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

RIP Commands

ip rip status

Enables/disables RIP on the switch. RIP performs well in small networks. By default, RIP packets are
broadcast every 30 seconds, even if no change has occurred anywhere in a route or service. Depending on
the size and speed of the network, these periodic broadcasts can consume a significant amount of band-
width.
ip rip status {enable | disable}
Syntax Definitions
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
RIP must be loaded on the switch
•
A RIP network can be no more than 15 hops (end-to-end). If there is a 16th hop, that network is identi-
fied as infinity and the packet is discarded.
Examples
-> ip rip status enable
Release History
Release 6.6.1; command was introduced.
Related Commands
ip load rip
show ip rip
MIB Objects
alaProtocolRip
alaRipProtoStatus
OmniSwitch 6250 CLI Reference Guide
Enables RIP routing on the switch.
Disables RIP routing on the switch.
default
disable
(ip load rip) to enable RIP on the switch.
Loads RIP into the switch memory.
Displays the RIP status and general configuration parameters (e.g.,
forced hold-down timer).
November 2009 page 33-3