Show Ip Rip Peer - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

show ip rip peer

Displays active RIP neighbors (peers). An active peer is a switch that has sent a RIP packet within the last
180 seconds. If a peer does not send a RIP packet (request or response) within 180 seconds, it is aged out
and will not be displayed.
show ip rip peer [ip_address]
Syntax Definitions
ip_address
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
N/A
Examples
-> show ip rip peer
Total
IP Address
----------------+------+-------+------+-------+-----------
100.10.10.1
output definitions
IP Address
Total recvd
Bad Packets
Bad Routes
Version
Secs since last update
Release History
Release 6.6.1; command was introduced.
page 33-30
32-bit IP address.
Bad Bad xxxxxxxxxxxxSecs since
Recvd Packets Routes Version
1 0 0
Peer IP address.
Total number of RIP packets received from the peer.
Number of bad packets received from peer.
Number of bad routes received from peer.
Peer's RIP version as seen on the last packet received.
Number of seconds since the last packet was received from the peer.
last update
2 3
OmniSwitch 6250 CLI Reference Guide
RIP Commands
November 2009