Cylinder Pressure Leakage Test - SSANGYONG Rodius 2013 Manual

(2) Cylinder pressure leakage test

▶
Specified value
Test condition: normal engine operating
temperature (80˚C)
Whole engine
at valve and cylinder head gasket
at piston ring
If the measured value of the compression pressure test is not within the specifications, perform the
cylinder pressure leakage test.
- Perform this test in the sequence of firing order.
- Do not test the cylinder pressure leakage with wet type test procedure. (do not inject the engine oil
into the combustion chamber)
2. Crank the engine for approx. 10 seconds by
using the start motor.
3. Record the test result and measure the
compression pressure of other cylinders with
same manner.
4. If the measured value is out of specified
value, perform the cylinder pressure leakage
test.
Specified value
below 25%
below 10%
below 20%
02-9
0000-00