Aggregate-Address - Dell Z9500 Command Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

ipv4 vrf vrf-

ipv6 unicast

vrf vrf-name

Not configured.

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

aggregate-address

To minimize the number of entries in the routing table, summarize a range of prefixes.

aggregate-address ip-address mask [advertise-map map-name] [as-

set] [attribute-map map-name] [summary-only] [suppress-map map-

Border Gateway Protocol

Enter the keyword ipv4 followed by the keyword vrf and

then the name of the VRF to enable VRF mode.

NOTE: Use this attribute to start a BGP instance

corresponding to either a specific address family in a

default VRF or an IPv4 address family in a non-default

Enter the keyword ipv6 followed by the keyword unicast

to enable BGPv6 mode.

(Optional) Enter the keyword vrf followed by the name of

the VRF to install the IPv6 route in that VRF.

NOTE: It will not be possible to enable VRF mode for

IPv6 unicast without configuring the corresponding IPv4

unicast mode for the same VRF. While deletion,

whenever the IPv4 VRF mode is deleted for the VRF, it

will automatically delete the IPv6 VRF configurations as

Added support for IPv6 VRF.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.