Stack-Unit Stack-Group - Dell S4810 Reference Manual

•

stack-unit stack-group

Configure the stacking unit and stacking group by specifying an ID when adding units to a stack to ensure
the unit is assigned to the correct group.
S4810
Syntax
stack-unit unit-id stack-group stack-group-id
To remove the current stack group configuration, use the no stack-unit unit-
id stack-group stack-id command.
Parameters
unit-id
stack-group-id
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version
8.3.12.0
Version
8.3.10.2
Usage The following message displays to confirm the command.
Information
Setting ports Fo 0/60 as stack group will make their interface
configs obsolete after a reload.[confirm yes/no]: If "y" is
entered, all non-default configurations on any member ports of
the current stack group will be removed when the unit is
rebooted.
1616
show system (S-Series and Z-Series)
or a specific member.
Enter the stack unit ID.
Enter the stack group ID. The range is from 0 to 15.
Introduced on the S4820T.
Reset command mode from EXEC to CONFIGURATION.
Introduced on the S4810.
NOTE: Any scripts used to streamline the stacking configuration process must
be updated to reflect the Command Mode change from EXEC Privilege to
CONFIGURATION to allow the scripts to work correctly.
– displays the status of all stack members
Stacking