Stack-Unit Priority - Dell S4810 Reference Manual

----------------------
0/49
0/50
0/51
1/49
1/50
2/49
2/51
2/52
Dell#
Related
•
Commands
•
•
•

stack-unit priority

Configure the ability of a switch to become the management unit of a stack.
S4810
Syntax
stack-unit stack-number priority 1-14
Parameters
stack-number
1–14
Defaults 0
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
1614
1/49
2/49
0/49
2/51
0/51
1/50
reset stack-unit – resets the designated stack member.
show hardware stack-unit
and output statistics of the designated component of the designated stack
member.
show system (S-Series and Z-Series)
members or a specific member.
upgrade (S-Series management unit and Z-Series)
image or system image of the S-Series management unit.
Enter the stack member unit identifier.
This preference parameter allows you to specify the
management priority of one backup switch over another,
with 0 the lowest priority and 14 the highest. The switch with
the highest priority value is chosen to become the
management unit if the active management unit fails or on
the next reload.
Introduced on the S4820T.
– displays the data plane or management plane input
– displays the current status of all stack
– upgrades the bootflash
Stacking