Radius Server Attribute 4; Radius Server Host - NETGEAR M6100 Series Reference Manual

no radius accounting mode
This command is used to set the RADIUS accounting function to the default value - i.e. the
RADIUS accounting function is disabled.
Format
no radius accounting mode
Mode Global Config

radius server attribute 4

This command specifies the RADIUS client to use the NAS-IP Address attribute in the
RADIUS requests. If the specific IP address is configured while enabling this attribute, the
RADIUS client uses that IP address while sending NAS-IP-Address attribute in RADIUS
communication.
Format
radius server attribute 4 [ipaddr]
Mode Global Config
Term Definition
4 NAS-IP-Address attribute to be used in RADIUS requests.
ipaddr The IP address of the server.
no radius server attribute 4
The no radius server attribute 4 command disables the NAS-IP-Address attribute
global parameter for RADIUS client. When this parameter is disabled, the RADIUS client
does not send the NAS-IP-Address attribute in RADIUS requests.
Format
no radius server attribute 4 [ipaddr]
Mode Global Config
Command example:
(NETGEAR Switch) (Config) #radius server attribute 4
(NETGEAR Switch) (Config) #radius server attribute 4

radius server host

This command configures the IP address or DNS name to use for communicating with the
RADIUS server of a selected server type. While configuring the IP address or DNS name for
the authenticating or accounting servers, you can also configure the port number and server
name. If the authenticating and accounting servers are configured without a name, the
command uses the Default_RADIUS_Auth_Server and Default_RADIUS_Acct_Server as the
default names, respectively. The same name can be configured for more than one
M6100 Series Switches
Management Commands
120
192.168.37.60