Set Slot Disable; Set Slot Power - NETGEAR M6100 Series Reference Manual

no slot
This command removes configured information from an existing slot in the system.
Format
no slot unit/slot cardindex
Mode Global Config
Note: Card index can be obtained by executing show supported cardtype
command in User EXEC mode.

set slot disable

This command configures the administrative mode of the slot(s). If you specify all, the
command is applied to all slots, otherwise the command is applied to the slot identified by
unit/slot.
If a card or other module is present in the slot, this administrative mode will effectively be
applied to the contents of the slot. If the slot is empty, this administrative mode will be applied
to any module that is inserted into the slot. If a card is disabled, all the ports on the device are
operationally disabled and shown as "unplugged" on management screens.
Format
set slot disable [unit/slot] | all]
Mode Global Config
no set slot disable
This command unconfigures the administrative mode of the slot or slots. If you specify all,
the command removes the configuration from all slots, otherwise the configuration is
removed from the slot identified by unit/slot.
If a card or other module is present in the slot, this administrative mode removes the
configuration from the contents of the slot. If the slot is empty, this administrative mode
removes the configuration from any module inserted into the slot. If a card is disabled, all the
ports on the device are operationally disabled and shown as "unplugged" on management
screens.
Format
no set slot disable [unit/slot] | all]
Mode Global Config

set slot power

This command configures the power mode of the slot(s) and allows power to be supplied to a
card located in the slot. If you specify all, the command is applied to all slots, otherwise the
command is applied to the slot identified by unit/slot.
M6100 Series Switches
Chassis Commands
29