NETGEAR M6100 Series Reference Manual page 28

no member
This command removes a blade from the chassis. The unit is the identifier of the blade to
be removed from the chassis. You execute this command on the primary management blade.
Format
no member unit
Mode Chassis Global Config
movemanagement
This command moves the management functionality from one blade to the other. The
fromunit is the identifier of the current management blade. The tounit is the identifier of
the new management blade. Upon execution, the entire chassis (including all interfaces in
the chassis) is unconfigured and reconfigured with the configuration on the new management
blade. After the reload is complete, you must perform all chassis management capabilities on
the new management blade. To preserve the current configuration across a management
blade move, execute the copy system:running-config nvram:startup-config
privileged EXEC command or save privileged EXEC command before you perform the
management blade move. A management blade move causes all routes and layer 2
addresses to be lost. You execute this command is executed on the management blade. The
system prompts you to confirm the management blade move.
Note: You can only configure the blade in slot 1 or slot 2 as a management
blade.
Format
movemanagement fromunit tounit
Mode Chassis Global Config
slot
This command configures a slot in the system. The unit/slot is the slot identifier of the
slot. The cardindex is the index into the database of the supported card types, indicating
the type of the card being preconfigured in the specified slot. The card index is a 32-bit
integer. If a card is currently present in the slot that is unconfigured, the configured
information will be deleted and the slot will be reconfigured with default information for the
card.
Format
slot unit/slot cardindex
Mode Global Config
Note: Card index can be obtained by executing show supported cardtype
command in User EXEC mode.
M6100 Series Switches
Chassis Commands
28