NETGEAR M6100 Series Reference Manual page 19

Table 5. CLI Command Modes (continued)
Command Mode Prompt
TACACS Config
Switch (Tacacs)#
DHCP Pool
Switch (Config dhcp-pool)#
Config
DHCPv6 Pool
Switch (Config dhcp6-pool)#
Config
Chassis Global
Switch (Config chassis)#
Config Mode
ARP Access-List Switch (Config-arp-access-list)# Contains commands to add ARP ACL rules
Config Mode
Support Mode
Switch (Support)#
The following table explains how to enter or exit each mode.
Table 6. CLI Mode Access and Exit
Command Mode Access Method
User EXEC This is the first level of access.
Privileged EXEC From the User EXEC mode, enter
enable.
Global Config From the Privileged EXEC mode, enter
configure.
VLAN Config From the Privileged EXEC mode, enter
vlan database.
M6100 Series Switches
NETGEAR Managed Switch Software Modules
19
Mode Description
Contains commands to configure properties
for the TACACS servers.
Contains the DHCP server IP address pool
configuration commands.
Contains the DHCPv6 server IPv6 address
pool configuration commands.
Allows you to access the Chassis Global
Config Mode.
in an ARP Access List.
Allows access to the support commands,
which should only be used by the
manufacturer's technical support personnel
as improper use could cause unexpected
system behavior and/or invalidate product
warranty.
Exit or Access Previous Mode
To exit, enter logout.
To exit to the User EXEC mode, enter exit or
press Ctrl-Z.
To exit to the Privileged EXEC mode, enter
exit, or press Ctrl-Z.
To exit to the Privileged EXEC mode, enter
exit, or press Ctrl-Z.