Show Checkpoint Statistics; Clear Checkpoint Statistics - NETGEAR M6100 Series Reference Manual

The movemanagement command (see
from the current management blade; however, the hardware is cleared and all blades
reinitialize.
Format
initiate failover
Mode Chassis Global Config Mode

show checkpoint statistics

This command displays general information about the checkpoint service operation.
Format
show checkpoint statistics
Mode Privileged Exec
Parameter
Messages Checkpointed
Bytes Checkpointed
Time Since Counters Cleared
Checkpoint Message Rate
Last 10-second Message Rate
Highest 10-second Message
Rate

clear checkpoint statistics

This command clears all checkpoint statistics to their initial values.
Format
clear checkpoint statistics
Mode Privileged Exec
M6100 Series Switches
movemanagement
Description
Number of checkpoint messages transmitted to the backup blade. Range:
Integer. Default: 0
Number of bytes transmitted to the backup blade. Range: Integer. Default: 0
Number of days, hours, minutes and seconds since the counters were reset to
zero. The counters are cleared when a blade becomes manager and with a
support command. Range: Time Stamp. Default: 0d00:00:00
Average number of checkpoint messages per second. The average is
computed over the time period since the counters were cleared. Range:
Integer. Default: 0
Average number of checkpoint messages per second in the last 10-second
interval. This average is updated once every 10 seconds. Range: Integer.
Default: 0
The highest rate recorded over a 10-second interval since the counters were
cleared. Range: Integer. Default: 0
Chassis Commands
42
on page 28) also transfers control