Chassis-Status Sample-Mode; General Chassis Commands - NETGEAR M6100 Series Reference Manual

General Chassis Commands

This section describes the commands you use to configure the chassis.
chassis
This command sets the mode to Chassis Global Config.
Format
chassis
Mode Chassis Global Config

chassis-status sample-mode

This command set the global status management mode.
Format
chassis-status sample-mode [cumulative | history [max-samples
<100-500>]]
Mode Chassis Global Config
Parameter
cumulative
history
max-samples
member
This command configures a blade. The unit is the identifier of the blade that you want to
add or remove from the chassis. The switchindex is the index into the database of the
supported blade types, indicating the type of the blade that is being preconfigured. The blade
index is a 32-bit integer. You execute this command on the management blade.
Format
member unit switchindex
Mode Chassis Global Config
Note: You can obtain the switch index by executing the show supported
switchtype command in user EXEC mode.
M6100 Series Switches
Description
Tracks the sum of received time stamp offsets cumulatively.
Tracks the history of received timestamps.
As an option for the history parameter, the maximum number of samples to keep. The
valid range is from 100 to 500.
Chassis Commands
27