Using Cli Help - NETGEAR M6100 Series Reference Manual

Using CLI Help

Enter a question mark (?) at the command prompt to display the commands available in the
current mode.
(NETGEAR Switch) >?
enable
help
logout
password Change an existing user's password.
ping
quit
show
telnet
Enter a question mark (?) after each word you enter to display available command keywords
or parameters.
(NETGEAR Switch) #network ?
ipv6
javamode
mac-address
mac-type
mgmt_vlan
parms
protocol
If the help output shows a parameter in angle brackets, you must replace the parameter with
a value.
(NETGEAR Switch) #network parms ?
<ipaddr>
none
If there are no additional command keywords or parameters, or if additional parameters are
optional, the following message appears in the output:
<cr>
You can also enter a question mark (?) after typing one or more characters of a word to list
the available command or parameters that begin with the letters, as shown in the following
example:
(NETGEAR Switch) #show m?
mac
mail-server
M6100 Series Switches
Enter into user privilege mode.
Display help for various special keys.
Exit this session. Any unsaved changes are lost.
Send ICMP echo packets to a specified IP address.
Exit this session. Any unsaved changes are lost.
Display Switch Options and Settings.
Telnet to a remote host.
Configure IPv6 parameters for system network.
Enable/Disable.
Configure MAC Address.
Select the locally administered or burnedin MAC
address.
Configure the Management VLAN ID of the switch.
Configure Network Parameters of the device.
Select DHCP, BootP, or None as the network config
protocol.
Enter the IP Address.
Reset IP address and gateway on management interface
Press Enter to execute the command
mac-addr-table
mbuf
NETGEAR Managed Switch Software Modules
24
mac-address-table
monitor