Show Users; Username Snmpv3 Encryption Encrypted; Show Users Long - NETGEAR M6100 Series Reference Manual

username snmpv3 encryption encrypted

This command specifies the des encryption protocol and the required encryption key for the
specified user. The encryption key must be 8 to 64 characters long.
Default no encryption
Format
username snmpv3 encryption encrypted username des key
Mode Global Config

show users

This command displays the configured user names and their settings. The show users
command displays truncated user names. Use the show users long command to display
the complete usernames. The show users command is only available for users with
read/write privileges. The SNMPv3 fields are displayed only if SNMP is available on the
system.
Format
show users
Mode Privileged EXEC
Term
User Name
Access Mode
SNMPv3 Access Mode
SNMPv3 Authentication
SNMPv3 Encryption

show users long

This command displays the complete user names of the configured users on the switch.
Format
show users long
Mode Privileged EXEC
Command example:
(NETGEAR Switch) #show users long
User Name
------------
admin
M6100 Series Switches
Definition
The name the user enters to login using the serial port, Telnet or Web.
Shows whether the user is able to change parameters on the switch (Read/Write) or is only
able to view them (Read Only). As a factory default, the "admin" user has Read/Write
access and the "guest" has Read Only access.
The SNMPv3 Access Mode. If the value is set to ReadWrite, the SNMPv3 user is able to
set and retrieve parameters on the system. If the value is set to ReadOnly, the SNMPv3
user is only able to retrieve parameter information. The SNMPv3 access mode may be
different than the CLI and Web access mode.
The authentication protocol to be used for the specified login user.
The encryption protocol to be used for the specified login user.
Management Commands
89