NETGEAR M6100 Series Reference Manual page 32

Command example:
(NETGEAR Switch) #show chassis
Management Plugged-in
Unit Role Model ID
------ ---------- ------------
1 Primary XCM8944-PoE+
2 Oper Standby XCM8948-uPoE
3 Chassis Mbr XCM8924X
If you specify a value for unit, the following information displays.
Term Definition
Unit The unit number of the blade.
Management Indicates whether the blade is the supervisor blade, the backup blade, a member blade, or
Status unassigned.
Hardware The hardware management preference of the blade. The hardware management
Management preference can be disabled or unassigned.
Preference
Admin The administrative management preference value that is assigned to the blade. This
Management preference value indicates how likely the blade is to be selected as the primary
Preference management blade.
Admin State Administrative state of the blade.
Power State Power state of the blade.
Switch Type The 32-bit numeric blade type.
Plugged-in Model The model identifier of the blade in the chassis. The Model Identifier is a 32-character field
Identifier that is assigned by the device manufacturer to identify the device.
Switch Status The blade status. Possible values are OK, Unsupported, Code Mismatch, Config
Mismatch, SDM Mismatch, or Not Present.
A mismatch indicates that the blade is running a different version of the code, SDM
template, or configuration than the management blade. The SDM Mismatch status
indicates that the blade is part of the chassis, but is running a different SDM template than
the management blade. A mismatch status is temporary; the blade automatically reloads
using the template that is running on the management blade. If a chassis firmware
synchronization operation is in progress, the status is shown as Updating Code.
Switch Description The blade description.
Detected Code in The version of code that is currently stored in FLASH memory on the blade. This code
Flash executes after the blade is reset. If the blade is not present and the data is from
preconfiguration, then the code version is "None".
POE D-Card The description of the PoE daughter card that is plugged into the blade.
description
POE D-Card PoE The firmware version that is running on the PoE controller of the daughter card that is
firmware version plugged into the blade.
M6100 Series Switches
Serial Switch
Number Status
------------- -------------
33J1245WF0021 OK
33J1245WF0022 CodeMismatch
33J1245WF0023 NoPwr
Chassis Commands
32
Version Admin PoE
Code State Card
----------- ------- --------
5.26.23.31 Enable XCM89P
5.26.23.31 Enable XCM89UP
A
5.26.23.31 Enable N/