Show Chassis - NETGEAR M6100 Series Reference Manual

If you supply a value for cardindex, the following output appears:
Term Definition
Card Type The 32-bit numeric card type for the supported card.
Model Identifier The model identifier for the supported card type.
Card Description The description for the supported card type.

show chassis

This command displays chassis status information about all blades in the chassis or, if you
specify the unit value, about a single blade. For blades that would normally be allowed to
join the chassis but do not have a matching chassis template ID, the blade status is shown as
STM Mismatch.
Format
show chassis [unit]
Mode Privileged EXEC
Term Definition
Unit The unit identifier assigned to the blade.
If you do not specify a value for unit, the following information displays:
Term Definition
Management Role Indicates whether the blade is the supervisor blade, a member blade, or an operational
backup blade, or whether the status is unassigned.
Preconfigured The model identifier of a preconfigured blade that is ready to join the chassis. The Model
Model Identifier Identifier is a 32-character field that is assigned by the device manufacturer to identify the
device.
Plugged-In Model The model identifier of the blade in the chassis. The Model Identifier is a 32-character field
ID that is assigned by the device manufacturer to identify the device.
Switch Status The chassis status. Possible values for this state are: OK, Unsupported, Code Mismatch,
SDM Mismatch, Config Mismatch, or Not Present. A mismatch indicates that a blade is
running a different software version, has a different SDM template, or has a different
configuration from the management blade. The SDM Mismatch status indicates that the
blade joined the chassis, but has a different SDM template than the management blade.
This status is temporary; the blade automatically reloads using the template of the chassis
manager.
If a chassis firmware synchronization operation is in progress, the status is shown as
Updating Code.
Code Version The detected version of code on this blade.
M6100 Series Switches
Chassis Commands
31