Password (User Exec); Enable Password (Privileged Exec) - NETGEAR M6100 Series Reference Manual

Command example:
(NETGEAR Switch)(Config-line)# password testtest
(NETGEAR Switch) (Config-line)# password
e8d63677741431114f9e39a853a15e8fd35ad059e2e1b49816c243d7e08152b052eafbf23b528d348cdba1b
1b7ab91be842278e5e970dbfc62d16dcd13c0b864 encrypted
(NETGEAR Switch) (Config-line)# password
Enter new password:********
Confirm new password:********
no password (Line Configuration)
Use this command to remove the password on a line.
Format
no password
Mode Line Config

password (User EXEC)

This command allow a user to change the password. The user must enter this command
after the password has aged. The user is prompted to enter the old password and the new
password.
Format
password
Mode User EXEC
Command example:
The following example shows the prompt sequence for executing the password command:
(NETGEAR Switch)>password
Enter old password:********
Enter new password:********
Confirm new password:********

enable password (Privileged EXEC)

Use the enable password configuration command to set a local password to control
access to the privileged EXEC mode.
Format
enable password [password [encrypted]]
Mode Privileged EXEC
M6100 Series Switches
Management Commands
93