Tacacs-Server Source-Interface; Tacacs-Server Timeout - NETGEAR M6100 Series Reference Manual

(NETGEAR Switch)(Config)#tacacs-server keystring
Enter tacacs key:********Re-enter tacacs key:********

tacacs-server source-interface

Use this command in Global Configuration mode to configure the source interface (Source IP
address) for TACACS+ server configuration. The selected source-interface IP address is
used for filling the IP header of management protocol packets. This allows security devices
(firewalls) to identify the source packets coming from the specific switch.
If a source-interface is not specified, the primary IP address of the originating (outbound)
interface is used as the source address.
Format
tacacs-server source-interface {unit/slot/port | loopback loopback-id |
vlan vlan-id}
Mode Global Config
Parameter Description
unit/slot/port The unit identifier assigned to the switch, in unit/slot/port format.
loopback-id The loopback interface. The range of the loopback ID is 0 to 7.
vlan-id Configures the VLAN interface to use as the source IP address. The range of the VLAN ID is 1 to
4093.
Command example:
(Config)#tacacs-server source-interface loopback 0
(Config)#tacacs-server source-interface 1/0/1
(Config)#no tacacs-server source-interface
no tacacs-server source-interface
Use this command in Global Configuration mode to remove the global source interface
(Source IP selection) for all TACACS+ communications between the TACACS+ client and
the server.
Format
no tacacs-server source-interface
Mode Global Config

tacacs-server timeout

Use the tacacs-server timeout command to set the time-out value in seconds for
communication with the TACACS+ servers. The seconds argument is a number in the range
of 1–30 seconds. If you do not specify a time-out value, the command sets the global
M6100 Series Switches
Management Commands
135