Using Cli Help - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Table 2-8. CLI Editing Conventions
Key Sequence
Ctrl-B
Ctrl-D
Ctrl-U, X
Ctrl-K
Ctrl-W
Ctrl-T
Ctrl-P
Ctrl-R
Ctrl-N
Ctrl-Y
Ctrl-Q
Ctrl-S
Ctrl-Z
Tab, <SPACE>
Exit
?

2.3.7 Using CLI Help

Enter a question mark (?) at the command prompt to display the commands available in
the current mode.
(switch) >?
enable
help
logout
ping
show
Enter a question mark (?) after each word you enter to display available command
keywords or parameters.
(switch) #network ?
javamode
parms
protocol
mgmt_vlan
2-10
Description
Go backward one character
Delete current character
Delete to beginning of line
Delete to end of line
Delete previous word
Transpose previous character
Go to previous line in history buffer
Rewrites or pastes the line
Go to next line in history buffer
Prints last deleted character
Enables serial flow
Disables serial flow
Return to root command prompt
Command-line completion
Go to next lower command prompt
List available commands, keywords, or parameters
Enter into user privilege mode.
Display help for various special keys.
Exit this session. Any unsaved changes are lost.
Send ICMP echo packets to a specified IP address.
Display switch options and settings.
Enable/Disable.
Configure Network Parameters of the router.
Select DHCP, BootP, or None as the network config
protocol.
Configure the Management VLAN ID of the switch.
v1.0, February 2007
Overview