Using Cli Help - NETGEAR GSM7224v2 - Layer 2 Managed Gigabit Switch Cli Manual

Table 8. CLI Editing Conventions (continued)
Key Sequence
Exit
?

Using CLI Help

Enter a question mark (?) at the command prompt to display the commands available in the current
mode.
(switch) >?
enable
help
logout
ping
quit
show
telnet
Enter a question mark (?) after each word you enter to display available command keywords or
parameters.
(switch) #network ?
javamode
mgmt_vlan
parms
protocol
If the help output shows a parameter in angle brackets, you must replace the parameter with a
value.
(switch) #network parms ?
<ipaddr>
If there are no additional command keywords or parameters, or if additional parameters are
optional, the following message appears in the output:
<cr>
You can also enter a question mark (?) after typing one or more characters of a word to list the
available command or parameters that begin with the letters, as shown in the following example:
Using the Command-Line Interface
Description
Go to next lower command prompt
List available commands, keywords, or parameters
Enter into user privilege mode.
Display help for various special keys.
Exit this session. Any unsaved changes are lost.
Send ICMP echo packets to a specified IP address.
Exit this session. Any unsaved changes are lost.
Display Switch Options and Settings.
Telnet to a remote host.
Enable/Disable.
Configure the Management VLAN ID of the switch.
Configure Network Parameters of the router.
Select DHCP, BootP, or None as the network config
protocol.
Enter the IP address.
Press Enter to execute the command
v1.0, July 2009
Managed Switch CLI Manual, Release 8.0
1-11