Ipv6 Multicast Spoofing - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Hide thumbs Also See for OmniSwitch 6250:

Table of Contents

IP Multicast Switching Commands

ipv6 multicast spoofing

Enables or disables MLD spoofing on the specified VLAN or on the system if no VLAN is specified.

ipv6 multicast [vlan vid] spoofing [{enable | disable}]

no ipv6 multicast [vlan vid] spoofing

Syntax Definitions

enable | disable

Platforms Supported

OmniSwitch 6250

Usage Guidelines

Use the no form of this command to remove an MLD spoofing entry on the specified VLAN or on the

system and return to its default behavior.

If the MLD spoofing is already enabled on the system, then the VLAN configuration will override the

system's configuration.

MLD spoofing refers to replacing a client's MAC and IP address with the system's MAC and IP

address when proxying aggregated MLD group membership information.

You can also restore the MLD spoofing to its default (i.e., disabled) setting on the system if no VLAN

is specified, by using only ipv6 multicast spoofing (i.e., ipv6 multicast spoofing).

You can also restore the MLD spoofing to its default (i.e., disabled) setting on the specified VLAN, by

using only ipv6 multicast vlan vid spoofing (i.e., ipv6 multicast vlan 2 spoofing).

-> ipv6 multicast spoofing enable

-> ipv6 multicast spoofing disable

-> ipv6 multicast spoofing

-> ipv6 multicast vlan 2 spoofing enable

-> ipv6 multicast vlan 2 spoofing disable

-> ipv6 multicast vlan 2 spoofing

-> no ipv6 multicast vlan 2 spoofing

OmniSwitch 6250 CLI Reference Guide

VLAN on which to apply the configuration.

Enable MLD spoofing.

Disable MLD spoofing.

November 2009