Install Bootrom - Extreme Networks ExtremeWare XOS Command Reference Manual

install bootrom

install bootrom <fname> {reboot} {msm <slotid>}
Description
Installs a new version of the ExtremeWare XOS BootROM image on the Summit X450 switch or the
BlackDiamond 10K switch.
Syntax Description
fname
reboot
msm
Default
N/A.
Usage Guidelines
When you download a BootROM image, the system asks if you want to install the image immediately
after the download is finished. If you choose to install the image at a later time, use this command to
install the software on the switch.
The BootROM image file is a .xbr file, and this file contains the executable code.
Local Filename Character Restrictions. This section provides information about the characters supported
by the switch for local and remote filenames.
When specifying a local or remote filename, the switch permits only the following characters:
Alphabetical letters, upper case and lower case (A-Z, a-z)
●
Numerals (0-9)
●
Period ( . )
●
Dash ( - )
●
Underscore ( _ )
●
When naming a local file, remember the requirements listed above.
Example
The following command installs the bootrom image file bd10K-1.0.1.5-bootrom.xbr:
install bootrom bd10K-1.0.1.5-bootrom.xbr
ExtremeWare XOS 11.3 Command Reference
Specifies the BootROM image file.
Reboots the switch after the image is installed.
Specifies the MSM where the BootROM image should be installed.
• A specifies the MSM installed in slot A.
• B specifies the MSM installed in slot B.
NOTE: This parameter is available only on the BlackDiamond 10K switch.
install bootrom
1627