Enable Bgp Peer-Group Capability - Extreme Networks ExtremeWare XOS Command Reference Manual

Software version 11.5

Hide thumbs Also See for ExtremeWare XOS:

Table of Contents

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

enable bgp peer-group capability

enable bgp peer-group <peer-group-name> capability [ipv4-unicast | ipv4-

multicast | route-refresh]

This command enables BGP Multiprotocol (MP) and route-refresh capabilities for a peer-group.

Syntax Description

peer-group-name

ipv4-unicast

ipv4-multicast

route-refresh

All capabilities are disabled by default.

Usage Guidelines

This command is not generally supported, and is not recommended for general use. However, to inter-operate with

Cisco routers for BGP graceful restart, you must enable IPv4 unicast address capability.

This command enables BGP Multiprotocol and route-refresh capabilities for a peer group. After the

capabilities have been enabled, the BGP peer will announce its capabilities to neighbors in an OPEN

The following command enables the route-refresh feature for the peer group outer:

enable bgp peer-group outer capability route-refresh

This command was first available in ExtremeWare XOS 10.1.

This command required an Advanced Core license in ExtremeWare XOS 11.1.

Platform Availability

This command is available on platforms with a Core or an Advanced Core license.

ExtremeWare XOS 11.5 Command Reference Guide

Specifies a peer group.

Specifies BGP MP unicast capabilities.

Specifies BGP MP multicast capabilities.

Specifies ROUTE-REFRESH message capabilities.

enable bgp peer-group capability

Extremeware xos 11.5