Config Bgp Neighbor Route-Map-Filter - Extreme Networks ExtremeWare Command Reference Manual

BGP Commands

config bgp neighbor route-map-filter

config bgp neighbor [<ip address> | all] route-map-filter [in | out] [none
| <route_map>]
Description
Configures a route map filter for a neighbor.
Syntax Description
ip address
all
in
out
none
route_map
Default
N/A.
Usage Guidelines
The route map filter can be installed on the input or output side of the router. The route map is used to
modify or filter the NLRI information and the path attributes associated with it when exchanging
updates with the neighbor.
You can use BGP peer groups to group together up to 200 BGP neighbors. All neighbors within the peer
group inherit the parameters of the BGP peer group. The following mandatory parameters are shared
by all neighbors in a peer group:
• remote AS
• source-interface
• out-nlri-filter
• out-aspath-filter
• out-route-map
• send-community
• next-hop-self
Example
The following command configures the route-map-filter filter for a neighbor based on the access profile
nosales:
config bgp neighbor 192.168.1.22 route-map-filter in nosales
1062
Specifies an IP address.
Specifies all neighbors.
Specifies to install the filter on the input side.
Specifies to install the filter on the output side.
Specifies to remove the filter.
Specifies a route map.
ExtremeWare Software 7.0.0 Command Reference Guide