Configure Stpd Maxage - Extreme Networks ExtremeWare Command Reference Manual

STP Commands

configure stpd maxage

configure stpd <spanning tree name> maxage <seconds>
Description
Specifies the maximum age of a BPDU in the specified STPD.
Syntax Description
spanning tree name Specifies an STPD name on the switch.
seconds Specifies the maxage time in seconds.
Default
20 seconds
Usage Guidelines
You should not configure any STP parameters unless you have considerable knowledge and experience
with STP. The default STP parameters are adequate for most networks.
The range for the
<seconds>
Note that the time must be greater than or equal to 2 * (Hello Time + 1) and less than or equal to 2 *
(Forward Delay –1).
Example
The following command sets the maximum age of STPD1 to 30 seconds:
configure stpd stpd1 maxage 30
History
This command was first available in ExtremeWare 2.0.
This command was added to the Summit "e" series of switches in ExtremeWare 6.2a and ExtremeWare
7.1e.
Platform Availability
This command is available on all platforms.
1444
parameter is 6 – 40 seconds.
ExtremeWare 7.5 Command Reference Guide