Configure Sflow Agent - Extreme Networks ExtremeWare Command Reference Manual

Hide thumbs Also See for ExtremeWare:

Table of Contents

Commands for Status Monitoring and Statistics

configure sflow agent

configure sflow agent <ip-address>

Configures the sFlow agent source IP address used in the sFlow UDP datagrams sent to the sFlow

This command is available only on the "i" series switches.

Syntax Description

Specifies the IP address from which sFlow data is sent on the switch.

The default IP address is 0.0.0.0.

Usage Guidelines

This command allows you to configure the IP source address that the sFlow agent uses when sending

data. Typically, you would set this to the IP address used to identify the switch in the network

management tools that you use. We recommend that you not leave this parameter in its default value.

One agent per switch is supported.

The following command sets the source IP address to 10.2.0.1 for UDP datagrams sent out by the sFlow

agent to the sFlow collector:

configure sflow agent 10.2.0.1

This command was first available in ExtremeWare 7.3.0.

Platform Availability

This command is available only on the "i" series platforms.

ExtremeWare 7.7 Command Reference Guide

Do you have a question about the ExtremeWare and is the answer not in the manual?

Extremeware 7.7