Table of Contents
Advertisement
JunosE 11.3.x Multicast Routing Configuration Guide
References
Before You Begin
Configuring the Switch Fabric Bandwidth
Enabling IP Multicast
ip multicast-routing
6
For more information about IP multicast, see the following resources:
A " traceroute" Facility for IP Multicast—draft-ietf-idmr-traceroute-ipm-07.txt (January
2001 expiration)
RFC 2858—Multiprotocol Extensions for BGP-4 (June 2000)
RFC 2932—IPv4 Multicast Routing MIB (October 2000)
RFC 3292—General Switch Management Protocol (GSMP) V3 (June 2002)
NOTE: IETF drafts are valid for only 6 months from the date of issuance.
They must be considered as works in progress. Refer to the IETF Web site
at http://www.ietf.org for the latest drafts.
You can configure multicasting on IPv4 and IPv6 interfaces.
For information about configuring IP and IPv6 interfaces, see JunosE IP, IPv6, and IGP
Configuration Guide.
For information about configuring multicast on IPv6 interfaces, see "Configuring IPv6
Multicast" on page 143.
By default, the switch fabric for the Juniper Networks ERX1440, ERX310, E120, and E320
Broadband Services Routers uses a bandwidth weighting ratio of 15:2 for
multicast-to-unicast weighted round robin (WRR). In the absence of strict-priority traffic,
and when both unicast and multicast traffic compete for switch fabric bandwidth, the
switch fabric allocates 15/17ths of the available bandwidth to multicast traffic and 2/17ths
of the available bandwidth to unicast traffic.
You can use the fabric weights command to change the ratio for multicast-to-unicast
traffic on the router switch fabric. For more information about the fabric weights
command, see JunosE System Basics Configuration Guide.
In this implementation, IP multicast works on virtual routers (VRs). By default, IP multicast
is disabled on a VR. To enable IP multicast on a VR, access the context for a VR, and then
issue the ip multicast-routing command.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 and is the answer not in the manual?
Questions and answers