Robot In Cold Environments; Start Of Robot In Cold Environments - ABB IRB 2600 Product Manual

2.7 Robot in cold environments

2.7.1 Start of robot in cold environments

Introduction
This procedure describes how to start the robot in a cold environment.
Starting in cold environment
Use this procedure to start the robot in a cold environment if it is not starting the
normal way:
1
2
3
If still not starting...
If the robot is still not starting after turning off motion supervision, use this
procedure:
1
Adjusting the speed
Depending on how cold the environment is and the program being used, the
ramping up of speed has to be adjusted. The table shows examples of how to
adjust the speed:
Work cycles
3 Work cycles
5 Work cycles
5 Work cycles
5 Work cycles
More than 5 Work cycles
If the program consists of large wrist movements, it is possible that the reorientation
velocity, which is always high in predefined velocities, needs to be included in the
ramping up.
Product manual - IRB 2600
3HAC035504-001 Revision: G
Action
Turn off motion supervision.
Start the robot.
When the robot has reached normal working
temperature, the motion supervision can be
turned on again.
Action
Start the robot with its normal program but
with reduced speed.
AccSet
20.20
40.40
60.60
100.100
100.100
© Copyright 2009-2015 ABB. All rights reserved.
2 Installation and commissioning
2.7.1 Start of robot in cold environments
Note
Note
The speed can be regulated with the
RAPID instruction AccSet.
Speed/velocity
100
400
600
1000
Max.
107