Suzuki Baleno Manual page 1600

1. Large-pitch
2. Small-pitch
3. Valve spring retainer
4. Valve spring seat
1. Valve cotter
5) Install new valve stem seal to valve guide.
After applying engine oil to seal and spindle of special tool
(Valve guide installer handle), fit oil seal to spindle, and then
install seal to valve guide by pushing special tool by hand.
After installing, check to be sure that seal is properly fixed to
valve guide.
Special Tool
(A): 09917-98221
(B): 09916-58210
NOTE:
D Do not reuse seal once disassembled. Be sure to install
D When installing, never tap or hit special tool with a ham-
1. Valve steam seal
6) Install valve to valve guide.
Before installing valve to valve guide, apply engine oil to stem
seal, valve guide bore, and valve stem.
7) Install valve spring and spring retainer.
Each valve spring has top end (large-pitch end) and bottom end
side (small-pitch end). Be sure to position spring in place with its bot-
tom end (small-pitch end) facing the bottom (valve spring seat
side
side).
8) Using special tool (Valve lifter), compress valve spring and fit
two valve cotters into groove in valve stem.
Special Tool
(A): 09916-14510
(B): 09916-14910
(C): 09919-28610
(D): 09916-84511
9) Install intake manifold, injectors, exhaust manifold and water
outlet cap to cylinder head.
ENGINE MECHANICAL (J18 TYPE ENGINE) 6A3-61
new seal.
mer or else. Install seal to guide only by pushing special
tool by hand. Tapping or hitting special tool may cause
damage to seal.