Suzuki Baleno Manual page 1530

6A1-70 ENGINE MECHANICAL (G13/G16 TYPE ENGINE)
1. Crank webs of No.2 and No.3 cylinders
3) There are five kinds of standard bearings differing in thickness.
To distinguish them, they are painted in the following colors at
the position as indicated in figure Each color indicates the fol-
lowing thickness at the center of bearing.
1.3 liter
Color painted
Green
Black
Colorless
(no paint)
Yellow
Blue
1.6 liter
Color painted
1. Paint
Green
Black
Colorless
(no paint)
Yellow
Blue
4) From numerals stamped on crank webs of No.2 and No.3 cylin-
ders and the alphabets stamped on mating surface of cylinder
block, determine new standard bearing to be installed to jour-
nal, by referring to table given below. For example, if numeral
stamped on crank web is "1" and alphabet stamped on mating
surface is "B", install a new standard bearing painted in "Black"
to its journal.
Alphabet stamped
on mating surface i
(Bearing ca bore (Bearing cap bore
dial.)
Numeral stamped on crank
web (Journal diameter)
1
A Green
f
B Black
C Colorless
New standard bearing to be installed.
Bearing thickness
1.996 – 2.000 mm
(0.0786 – 0.0787 in.)
1.999 – 2.003 mm
(0.0787 – 0.0789 in.)
2.002 – 2.006 mm
(0.0788 – 0.0790 in.)
2.005 – 2.009 mm
(0.0790 – 0.0791 in.)
2.008 – 2.012 mm
(0.0791 – 0.0792 in.)
Bearing thickness
1.998 – 2.002 mm
(0.0787 – 0.0788 in.)
2.001 – 2.005 mm
(0.0788 – 0.0789 in.)
2.004 – 2.008 mm
(0.0789 – 0.0791 in.)
2.007 – 2.011 mm
(0.0790 – 0.0792 in.)
2.010 – 2.014 mm
(0.0791 – 0.0793 in.)
2 3
Black Colorless
Colorless Yellow
Yellow Blue