Suzuki Baleno Manual page 1575

6A3-36 ENGINE MECHANICAL (J18 TYPE ENGINE)
1. Match mark on crank timing
sprocket
2. Timing mark on lower crankcase
1. Arrow mark on idler sprocket
2. Knock pin of intake camshaft
3. Knock pin of exhaust camshaft
4. Timing mark of intake side
5. Timing mark of exhaust side
1. Yellow plate
2. Match mark of 2nd timing chain (Arrow mark)
1. Dark blue
2. Arrow mark on intake camshaft timing sprocket
3. Arrow mark on exhaust camshaft timing sprocket
INSTALLATION
1) Check that match mark on crank timing sprocket is in match with
timing mark on lower crankcase as shown in figure.
2) Check that arrow mark on idler sprocket faces upward as shown
in figure.
3) Check that knock pins of intake and exhaust camshafts are
aligned with timing marks on cylinder head as shown in figure.
4) Install 2nd timing chain by aligning yellow plate of 2nd timing
chain and match marks on idler sprocket.
5) Install sprockets to intake and exhaust camshafts by aligning
dark blue plate of 2nd timing chain, match marks on intake
sprocket and exhaust sprocket respectively.
CAUTION:
Do not turn camshaft more than necessary.
If turned excessively, valve and piston may get dam-
aged.
NOTE:
As an arrow mark is provided on both sides, camshaft tim-
ing sprocket has no specific installation direction.