Suzuki Baleno Manual page 1532

6A1-72 ENGINE MECHANICAL (G13/G16 TYPE ENGINE)
Engine displacement
1.3 liter
1.6 liter
Alphabets stamped
on mating surface
of cylinder block
D If necessary, regrind crankshaft journal and select undersize
bearing to use with it as follows.
1) Regrind journal to the following finished diameter.
2) Using micrometer, measure reground journal diameter. Mea-
surement should be taken in two directions perpendicular to
each other in order to check for out-of-round.
3) Using journal diameter measured above and alphabets
stamped on mating surface of cylinder block, select an under-
size bearing by referring to table given below. Check bearing
clearance with newly selected undersize bearing.
44.744 – 44.750 mm
(1.7616 – 17618 in.)
51.744 – 51.750 mm
(2.0371 – 2.3773 in.)
A Green & Red
B Black & Red
C Red only
Rear Oil Seal
Carefully inspect oil seal for wear or damage. If its lip is worn or
damaged, replace it.
1. Rear oil seal
For oil seal installation, press-fit rear oil seal so that oil seal housing
end face is flush with oil seal end face.
1. Oil seal
2. Oil seal housing
Finished diameter
1.3 liter engine: 44.732 – 44.750 mm
(1.7611 – 1.7618 in.)
1.6 liter engine: 51.732-51.750 mm
(2.0367-2.0373 in.)
Measured journal diameter
44.738 – 44.744 mm
(1.7613 – 1.7616 in.)
51.738 – 51.744 mm
(2.0369 – 2.0371 in.)
Black & Red
Red only
Yellow & Red
Undersize bearing to be installed
44.732 – 44.738
(1.7611 –1.7613 in.)
51.732 – 51–738 mm
(2.0367 – 2.0369 in.)
Red only
Yellow & Red
Blue & Red