Suzuki Baleno Manual page 1521

1. Propeller shaft No.1 pipe
1. Mounting member
2. Left mounting
3. Right mounting
4. To front member
5. Suspension frame
6. To body
7. Right mounting bracket
8. Right mounting bracket stiffener
19) Remove propeller shaft No.1 from transmission case flange
referring to Section 4B.
20) Remove drive shaft joints from differential gear of transmis-
sion.
Refer to Section 4 or 4A (DRIVE SHAFT) for procedure to dis-
connect drive shaft joint.
For engine and transmission removal, it is not necessary to re-
move drive shafts from steering knuckle.
21) Remove A/C compressor from compressor bracket with hose
still attached. (if equipped)
NOTE:
Suspend removed compressor at a place where no dam-
age will be caused during removal and installation of en-
gine assembly.
22) Disconnect P/S hose from P/S oil pump and remove high
pressure hose clamp from bracket. (if equipped)
NOTE:
Plug pipe, hose and pump port.
23) Install lifting device.
24) Remove mounting member from front member and suspen-
sion frame (2WD).
25) Remove suspension frame from body with stabilizer bar at-
tached (4WD).
26) Remove engine left mounting from body.
27) Remove engine right mounting from right mounting bracket
and stiffener.
Front side
1. Sedan & WAGON
A. 3 A / T
B. 4 A / T
C. M / T
ENGINE MECHANICAL (G13/G16 TYPE ENGINE) 6A1-61