Suzuki Baleno Manual page 1520

6A1-60 ENGINE MECHANICAL (G13/G16 TYPE ENGINE)
1. Fuel feed hose 3. Fuel pressure regulator
2. Fuel return hose
1. Exhaust No.1 pipe
10) Disconnect the following electric wires:
D Ignition coil assembly
D Ground wires from intake manifold and throttle body
D Engine oil pressure switch
D EGR valve (if equipped)
D EVAP canister purge valve (if equipped)
D Engine coolant temp. sensor
D Fuel injectors
D Power steering pressure switch (if equipped)
D Oxygen sensor (if equipped)
D Back-up light switch (M/T)
D Transmission range switch (A/T)
D Forward clutch revolution sensor (4 A/T)
D A/T vehicle speed sensor (A/T)
D Generator
D Starter
D Battery negative cable from transmission
D Vehicle speed sensor
D TP sensor
D IAC valve
D MAP sensor
D CMP sensor
D CKP sensor
and release above wire harnesses from clamps.
11) Remove clutch operating cylinder from transmission with hose
still attached (M/T).
NOTE:
Suspend removed clutch operating cylinder at a place
where no damage will be caused during removal and
installation of engine assembly.
12) Disconnect fuel feed hose from feed pipe and return hose from
fuel pressure regulator.
13) Disconnect heater inlet and outlet hoses (if equipped).
14) Remove right and left engine under covers.
15) Remove jacking front panel (4WD).
16) Remove exhaust No.1 pipe.
17) Remove gear shift control shaft from transmission remove ex-
tension rod (2WD with M/T).
18) Drain engine and transmission oil.