Suzuki Baleno Manual page 1513

Piston Rings
To measure end gap, insert piston ring into cylinder bore and then
measure the gap by using thickness gauge.
If measured gap is out of specification, replace ring.
NOTE:
Decarbon and clean top of cylinder bore before inserting pis-
ton ring.
Piston Piston
ring end
gap ga
1. Cylinder block
2. Feeler gauge
3. Piston ring
4. 120 mm (4.72 in.)
Connecting Rod
D Big-end side clearance:
Check big-end of connecting rod for side clearance, with rod
fitted and connected to its crank pin in the normal manner. If
measured clearance is found to exceed its limit, replace con-
necting rod.
Big-end side
clearance
D Connecting rod alignment:
Mount connecting rod on aligner to check it for bow and twist
and, if limit is exceeded, replace it.
Limit on bow : 0.05 mm (0.0020 in.)
Limit on twist: 0.10 mm (0.0039 in.)
ENGINE MECHANICAL (G13/G16 TYPE ENGINE) 6A1-53
Item Standard
0.2 – 0.35 mm
Top ring
(0.0079 – 0.0137 in.)
0.2 – 0.35 mm
2nd ring
(0.0079 – 0.0137 in.)
0.2 – 0.7 mm
Oil ring
(0.0079 – 0.0275 in.)
Item Standard
0.10 – 0.20 mm
(0.0039 – 0.0078 in.)
Limit
0.7 mm
(0.0275 in.)
0.7 mm
(0.0275 in.)
1.7 mm
(0.0669 in.)
Limit
0.35 mm
(0.0137 in.)