6A3-80 ENGINE MECHANICAL (J18 TYPE ENGINE)
1. Water pump
2. Engine front mounting bracket
1. Lower crankcase
2. Bolt (10 mm thread diameter)
3. Bolt (8 mm thread diameter)
REMOVAL
1) Remove engine assembly from vehicle as previously outlined.
2) Remove clutch and flywheel. For clutch removal, refer to Sec-
tion 7C1.
Special Tool
(A): 09924-17810
1. Flywheel bolt
3) Remove throttle body, intake manifold, exhaust manifold.
4) Remove oil pan.
5) Remove oil pump with oil pump strainer.
6) Remove cylinder head cover.
7) Remove timing chain cover. Refer to item "TIMING CHAIN
COVER" in this section for removal.
8) Remove timing chain guide, chain tensioner, tensioner adjust-
ers, 2nd timing chain and 1st timing chain.
9) Remove cylinder head assembly.
10) Remove pistons and connecting rods.
11) Remove water pump and heater outlet pipe.
12) Remove engine front mounting bracket.
13) Loosen crankcase bolts, the following sequence in figure and
remove them.
14) Remove crankshaft from cylinder block.