Figure 12-10 Networking Of Outputting System Log To Log Host - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide

Figure 12-10 Networking of outputting system log to log host

Configuration steps
Step 1 Configure the IP address of the ISCOM2600G-HI series switch.
Raisecom#config
Raisecom(config)#interface vlan 1
Raisecom(config-vlan1)#ip address 20.0.0.6 255.0.0.0
Raisecom(config-vlan1)#exit
Step 2 Configure the system log to be output to the log host.
Raisecom(config)#logging on
Raisecom(config)#logging time-stamp log datetime
Raisecom(config)#logging rate-limit 2
Raisecom(config)#logging host 20.0.0.168 warnings
Checking results
Use the show logging command to show configurations of system log.
Raisecom#show logging
Syslog logging:
Dropped Log messages:
Dropped debug messages:
Rate-limited:
Squence number display:
Debug level time stamp:
Log level time stamp:
Log buffer size:
Debug level:
Syslog history logging:
Syslog history table size:1
Dest
-------------------------------------------------------------------------
---
buffer
console
trap
file
Log host information:
enable
0
0
2 messages per second
disable
none
datetime
4kB
low
disable
Status Level
enable informational(6) 10
enable informational(6) 10
disable warnings(4)
enable debugging(7)
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
LoggedMsgs DroppedMsgs Discriminator
0
0
0 0
17 0
12 System management
0
0
0
0
517