Configuring Ospf Route Attributes - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
3



5.7.3 Configuring OSPF route attributes

Configuring interface cost
Configure the interface cost for the ISCOM2600G-HI series switch as below.
1
2
3
Configuring reference bandwidth
Configure the OSPF reference bandwidth for the ISCOM2600G-HI series switch as below.
1
2
3
Step
Raisecom(config-router-
ospf)#network
mask area area-id
If you manually configure the router-id by configuring optional parameters in the
router ospf process-id [ router-id router-id ] command, the OSPF process will
use the router-id by precedence. Otherwise, the process will automatically elect a
router-id.
If the process has configured or elected the router-id, and you modify the router-id,
the modification will take effect after restart.
Step
Raisecom#config
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigabitethernet1/1/port)#ip
ospf cost
Step
Raisecom#config
Raisecom(config)#router ospf
process-id
Raisecom(config-router-
ospf)#reference-bandwidth
bandwidth
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Command
ip-address wild-card-
Command
cost
Command
router-id
[ router-id
Description
Configure the network segment
included by the OSPF area.
Description
Enter global configuration mode.
Enter Layer 3 interface
configuration mode.
Configure the route cost of the IP
interface.
By default, it is not configured.
Description
Enter global configuration mode.
Start an OSPF process, and enter
]
OSPF configuration mode.
Configure the reference
bandwidth of the link.
By default, it is 110 Mbit/s.
5 IP services
237