Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
1.6.4 Configuring time and time zone
Configure the time and time zone for the ISCOM2600G-HI series switch as below.
Step
1
2
3
1.6.5 Configuring DST
Configure DST for the ISCOM2600G-HI series switch as below.
Step
1
2
1.6.6 Configuring NTP
Configure NTP for the ISCOM2600G-HI series switch as below.
Step
1
Command
Raisecom#clock set
second year month day
Raisecom#clock timezone { + | -
}
hour minute timezone-name
Raisecom#clock display { default
| utc }
Command
Raisecom#clock summer-time enable
Raisecom#clock summer-time
week
recurring {
mon | sat | sun | thu | tue | wed }
month hour minute
{ fri | mon | sat |sun | thu | tue
month hour minute offset-mm
| wed }
When you configure system time manually, if the system uses DST, such as DST
from 2 A.M. on the second Sunday, April to 2 A.M. on the second Sunday,
September every year, you have to adjust the clock one hour forward during this
period, configure time offset as 60 minutes, and the period from 2 A.M. to 3 A.M.
on the second Sunday, April each year is inexistent. The time setting by manual
operation during this period shows failure.
The summer time in southern hemisphere is opposite to the northern hemisphere,
which is from September to April of next year. If you configure the start time later
than the end time, the system will suppose that it is in the Southern Hemisphere.
In other words, the summer time is from the start time this year to the ending time
of next year.
Command
Raisecom#config
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
hour minute
Configure system time.
Configure the local time zone.
Configure system clock display mode.
| last } { fri |
week
{
| last }
Enter global configuration mode.
1 Basic configurations
Description
Description
Enable DST.
Configure calculation period for
system DST.
Underlined command lines
indicate the termination DST.
Description
34
Advertisement
Table of Contents
