Raisecom ISCOM2600G-HI (A) Series Configuration Manual page 399

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
1
2
3
Only when the local end is configured with remote loopback response can EFM OAM
remote loopback of the peer end take effect.
Configuring OAM link monitoring
OAM link monitoring is used to detect and report link error in different conditions. When the
detection link has a fault, the ISCOM2600G-HI series switch notifies the peer of the error
generated time, window and threshold by OAM event, the peer receives event notification and
reports the NView NNM system through SNMP Trap. Besides, the local device can directly
report events from a specified interface to the NView NNM system center through SNMP
Trap.
Configure OAM link monitoring for the ISCOM2600G-HI series switch as below.
Step
1
2
3
4
5
6
Step
Raisecom#config
Raisecom(config)#interface
interface-type interface-
number
Raisecom(config-
gigaethernet1/1/1)#oam
loopback { ignore | process }
Raisecom#config
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigaethernet1/1/1)#oam errored-frame
window
window
Raisecom(config-
gigaethernet1/1/1)#oam errored-
frame-period window
threshold
Raisecom(config-
gigaethernet1/1/1)#oam errored-
frame-seconds window
threshold
threshold
Raisecom(config-
gigaethernet1/1/1)#oam errored-
symbol-period window
threshold threshold
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Command
Command
threshold
threshold
window
threshold
window
window
Description
Enter global configuration mode.
Enter physical layer interface
configuration mode.
Configure the Layer 2 physical
interface to ignore or process EFM
remote loopback.
Description
Enter global configuration mode.
Enter physical layer interface
configuration mode.
Configure errored frame monitor
window and threshold.
Configure errored frame period
event monitor window and
threshold.
Configure link errored frame
second window and threshold.
Configure errored code window
and threshold.
9 OAM
368