Static Route; Introduction; Preparing For Configurations; Configuring Static Route - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide

5.5 Static route

5.5.1 Introduction

A route is required for communication among different devices in one VLAN, or different
VLANs. The route is used to transmit packets through network to destination, which adopts
routing table for forwarding packets.
Default route
The default route is a special route that can be used only when there is no matched item in the
routing table. The default route appears as a route to network 0.0.0.0 (with mask 0.0.0.0) in
the routing table. You can show configurations of the default route by using the show ip route
command. If the ISCOM2600G-HI series switch has not been configured with default route
and the destination IP of the packet is not in the routing table, the ISCOM2600G-HI series
switch will discard the packet and return an ICMP packet to the Tx end to inform that the
destination address or network is unavailable.
Static route
A static route is the route configured manually, thus bringing low requirements on the system.
It is available to simple, small, and stable network. The disadvantage is that it cannot adapt to
network topology changes automatically and needs manual intervention.

5.5.2 Preparing for configurations

Scenario
Configure the static route for simple network topology manually to establish an
intercommunication network.
Prerequisite
Configure the IP address of the VLAN interface correctly.

5.5.3 Configuring static route

Configure the static route for the ISCOM2600G-HI series switch as below.
Step
1
2
Command
Raisecom#config
Raisecom(config)#ip route
address mask-address next-hop
[ interface-type interface-
num distance
] [ distance
text
[ description
tag
] [ track bfd-session
session-id ]
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Enter global configuration mode.
ip-
Configure the IPv4 static route. The
device supports BFD. When the
interface is Down, BFD becomes
]
Down and the static route is deleted.
] [ tag
When the interface is Up, BFD
becomes Up and the static route is
added to the routing table.
5 IP services
Description
220