Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
PoA active and the local PoA standby. When faults at the local PoA are cleared, the system
will perform fault recovery, reselecting the local PoA as the active one.
11.5.2 Preparing for configurations
Scenario
Create an ICCP channel on the PoA. Make the two independent PoAs form a virtual
redundant ICG which can implement mLACP.
Prerequisite
The special VLAN for the ICCP channel has been established. The special Layer 3 interface
IP address for the special VLAN of the 2 PoAs is configured differently and in the same
network segment. The LAG in each device has been established. The interfaces which are to
be added to the LAG have been switched to Layer 2 interfaces and are added to the LAG
without any configurations. Interfaces on the DHD which are to be added to the LAG should
be the ones connecting all links to the 2 PoAs. However, interfaces on the 2 PoAs which are
to be added to the LAG contain the local interfaces which connect the DHD only.
11.5.3 Configuring ICCP channel
Configure the ICCP channel for the ISCOM2600G-HI series switch as below.
Step
1
2
3
4
5
Configuration
Raisecom#config
Enter global configuration mode.
Raisecom(config
Configure the IP address of the local interface in the ICCP
)#iccp local-ip
channel.
ip-address
Raisecom(config
Create a communication channel and enter ICCP
)#iccp-channel
configuration mode.
channel-id
Raisecom(config
Configure the IP address of the peer ICCP.
-iccp)#member-
ip
ip-address
Raisecom(config
Enable ICCP.
-iccp)#iccp
By default, it is disabled.
enable
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Description
The configured IP address must be the IP address
of the local Layer 3 interface. When modifying the
IP address of the local Layer 3 interface, you have
to reconfigure the IP address of the local ICCP.
The configured IP address must be the IP address
of the peer Layer 3 interface. When modifying the
IP address of the peer Layer 3 interface, you have
to reconfigure the IP address of the ICCP peer.
11 Reliability
476
Advertisement
Table of Contents
